My Courses

DC Theory

At the end of this module, students will understand the fundamentals of Electronic Theory.

DC Electronics

• DC Electronics - $499.00

Learning Objective At the end of this module, students will understand the fundamentals of DC Electronics Objectives Learn to use a breadboard

2024 Device Builds

40 Hours Students will complete 12 IED Circuit Builds 2024 Course Schedule: February: Timer Armed Open and Closed Switch March: One Battery Collapsing Circuit April: EOL Alarm Circuit May: Collar Bomb June: Balanced Detonators July: RC Armed RF Detector August: LED Light Sensor September: Up the IRS October: Touch Release Hostage Device November: Microwave Sensor […]

Wire Diagnostics w/ Arduino Wire Attack Trainer

Registration Closes 10DEC21 FREE ONLINE TRAINING COURSE Date: December 16, 2021 @ 11:00 AM (PST) Terminal Objectives We will cover wire diagnostics from a practical perspective by relating what you see on your meter to what you know about Ohm’s Law. This will allow you to establish wire pairs, determine the sensor and panel side […]

Capacitors

Explain how capacitors are used in the electrical circuit of an IED.

Live Training

Live training directly from your browser. Check out the community for training dates. CLICK HERE TO ACCESS THE ARCHIVE OF PAST EVENTS

Resistors

Discuss what a resistor is and learn how to use resistors in a circuit.

Training Wednesdays

Join us each week for FREE live training sessions. July 27, 2022 – Wire Attack (Replay)

Fusion 360 and 3D Printing

5 Days / 40 Hours Students will learn the Fusion 360 software environment and 3D printing techniques to print their designs.

Test

Transistors

At the end of this module, students will be able to explain how transistors are used in the electrical circuit of an IED.

MOSFETs

Explain how MOSFETs and SCRs are used in the electrical circuit of an IED

OCSD Fusion 360 and 3D Printing

5 Days / 40 Hours Students will learn the Fusion 360 software environment and 3D printing techniques to print their designs.

EOD 3D Printing Online DEC 8-12 2025

5 Days / 40 Hours Students will learn the Fusion 360 software environment and 3D printing techniques to print their designs.

Arduino

Students will be able to install the Arduino Integrated development environment and understand how to load code into their Arduino.